What does the cisco reload command do?

What does the cisco reload command do?

The Cisco “reload” command is used on almost all IOS Cisco networking devices (routers, switches etc) to restart (or reboot) the appliance.

How do I get to Global configuration Mode Cisco?

To enter global configuration mode, enter the configure command. Global configuration From privileged EXEC mode, enter the configure command. To exit to privileged EXEC mode, enter the exit or end command, or press Ctrl-Z. To enter interface configuration mode, enter the interface configuration command.

How do you copy and paste on a Cisco switch?

To copy, you can either select Edit > Copy from the text editor’s menu, or hold down the CTRL key and simultaneously press the C key. 17. Switch to the HyperTerminal window and issue the configure terminal command at the Router# prompt and select Enter.

How do I create a stack on a Cisco switch?

Steps to configure the switches in the stack: Attach the stacking cable to the rest of the members. Power up the members one at a time and based on the order of your choice. Example, if switch 2 is the 2nd switch, then power this switch after the master has been powered up and stacking cable has been applied.

How do you power cycle a Cisco switch?

Disconnect all Ethernet cables from the switch. Using a pin, press and hold the Reset button on the switch for 15 to 20 seconds.

How do I paste a configuration on a Cisco switch?

Paste the configuration file into the router by selecting Edit > Paste to Host on the HyperTerminal menu. After the configuration has finished pasting, and the router brings you back to the configuration prompt, issue the copy running-config startup-config command. This writes the configuration into memory.

How do I install a text file on a Cisco switch?

  1. Connect to the switch/router that needs the configuration.
  2. Open the config.
  3. Highlight the entire contents of the config.
  4. Copy the selected text to the Windows clipboard.
  5. Switch to the HyperTerminal window, and issue the configure terminal command at the Router# prompt.