What model is my Rheem furnace?
What model is my Rheem furnace?
You can find the model (and serial) number on a data plate. On the RHEEM furnace, the data plate is located inside the furnace. On the RHEEM air conditioner or heat pump, the model number is printed above the refrigerant valves on the unit’s backside.
Why is my Rheem furnace not heating?
Sometimes, if the flame sensor is dirty, it will fail to detect a flame. Try cleaning the flame sensor with a fine abrasive pad. If the furnace still doesn’t heat, replace the flame sensor. The draft inducer motor draws air into the heat exchanger and then exhausts it out the flue.
How does a Rheem furnace work?
These units heat air in one location and, using ductwork and vents, distribute that air throughout your home. The main components of a Rheem furnace include a thermostat, electrical controls, burners, blower, gas valve, heat exchanger, ductwork, and ventilation.
Should I replace a 30 year old furnace?
Regardless of the logic you follow, the 30-year mark is at or close to the maximum lifespan you should expect from your furnace. Even though furnaces can last 30 years or beyond, most experts recommend that you start shopping for a new furnace when your existing unit is 15 years old.
How do I find out how old my furnace is?
You might want to try searching for “find manufacturing date of YOUR BRAND furnace.” The serial number normally provides insight into the age of your system, but it does change among brands. For example, for some brands, the first four numbers indicate the year and month it was manufactured.
Why is my Rheem furnace blowing cold air?
Your furnace may be blowing cold air because the filter is too dirty. A dirty air filter blocks airflow over the furnace’s heat exchanger, causing it to overheat. When overheating, your furnace can trip a high limit switch, causing the furnace burners to shut off so that the heat exchanger does not crack.
How do you reset a Rheem furnace?
8 Steps to Reset Your Rheem Furnace
- Check to see if the pilot light is off.
- Set the thermostat to the lowest possible setting.
- Switch off the power.
- Close the gas supply to the furnace.
- Reignite the pilot light with a matchstick or lighter.
- Turn on the power and the gas supply.
- Press the reset button and hold for 30 seconds.
How do you start a Rheem furnace?
Place the breaker in the “On” position to supply electricity to your furnace. Set your wall thermostat to your desired temperature setting. The direct spark igniter lights the burner once the ambient room temperature trips the wall thermostat, signaling the thermostat to turn on the furnace.