Why is my Whirlpool Duet washing machine not draining?
Why is my Whirlpool Duet washing machine not draining?
You need to make sure that the drain hose is not kinked at all. Straighten the hose to make sure that there is enough water flow and that you also remove any blockages from the drainpipe well. Ensure that you are using a U-shaped drain and secure it properly. Your instruction manual will show you how to do this.
Why is my Whirlpool front load washer not draining?
The drain hose may be too far down inside the drainpipe (standpipe) or laundry tub. Drained water can siphon back into the washer if the drain hose extends too far. Make sure that the drain hose does not extend more than 4.5″ (113 mm) into the drainpipe or laundry tub.
How do you fix a Whirlpool washer that won’t drain?
What to Do When Your Washing Machine Won’t Drain
- Perform a Master Reset. Unplug your washer for about one minute.
- Test the Lid Switch Assembly.
- See if the Drain Hose is Kinked.
- Check the Drain Hose or Pump for Clogs.
- Clean out the Coin Trap.
- Check the Water Level Control.
- Schedule Washing Machine Repair.
How do I drain the water from my Whirlpool Duet washer?
Remove the screws with a 1/4-inch nut driver. Pull the bottom of the access panel toward you and pull it down to release it from the washer. The drain pump is under the Duet washer drum and has two hoses.
How do I force my Whirlpool washer to drain?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
Why is my front loading washing machine not draining?
Clogged Drain Hose Over time, debris can clog the drain hose and prevent your washer from draining. A twisted or coiled drain hose can also inhibit the free flow of water. Check behind the washer and straighten a kinked hose. If this does not solve the problem, unplug and clean the hose to eliminate any residue.
How do I know if my whirlpool drain pump is bad?
Put your finger into the drain outlet and feel the impellers if the pump freely turns. One or more of them may be broken. If so, you’ll be able to feel them while you’re turning the pump flywheel with your other hand. You also may see broken pieces of plastic in the bottom of the pump housing.
Why is my front load washer not draining?
Over time, debris can clog the drain hose and prevent your washer from draining. A twisted or coiled drain hose can also inhibit the free flow of water. Check behind the washer and straighten a kinked hose. If this does not solve the problem, unplug and clean the hose to eliminate any residue.
How do you check a drain pump filter on a Whirlpool Duet washer?
Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter. Remove the drawer by releasing the tab on each side.
Why is my Whirlpool not draining?
If your washer’s drain hose is kinked or bent, the washer will not be able to drain properly. The drain hose may also be obstructed by a small article of clothing. Check your drain hose and remove any obstructions, and straighten it if it’s bent. Make sure the hose is placed less than eight feet above the floor.