How do you clone ATmega328P?

How do you clone ATmega328P?

Install the ATmega328/168/8 chip, so the notched side of the IC is at the top. Add the 10KΩ pull-up resistor to the +5V and connect the other end to the RESET pin on the ATmega (pin 1). Add jumpers for power and ground for the following pins.

Can I program ATmega328P with Arduino?

Once your ATmega328P has the Arduino bootloader on it, you can upload programs to it using the USB-to-serial converter (FTDI chip) on an Arduino board.

Can you read code from an Arduino?

The Arduino bootloader is a variant of the original STK500 protocol (1. x). The character ‘t’ (ASCII 0x74) is the “Read Page” command. So perhaps it is possible to pull the program out through the serial port via the bootloader using AVRDUDE… But at best I reckon it will take some fancy timing to pull it off.

How do I get an Arduino code from my computer?

You can’t download a program from an Arduino to a PC because the source code only exists on the PC. What goes on the Arduino would be unintelligible if you did download it. I presume you have the source code from which the existing Arduino program was compiled and uploaded.

How do I program ATmega328P with Arduino as ISP?

Burning the Bootloader

  1. Upload the ArduinoISP sketch onto your Arduino board.
  2. Wire up the Arduino board and microcontroller as shown in the diagram to the right.
  3. Select “Arduino Duemilanove or Nano w/ ATmega328” from the Tools > Board menu.
  4. Select “Arduino as ISP” from Tools > Programmer.
  5. Run Tools > Burn Bootloader.

Is Arduino due the same as duemilanove?

FYI- Duemilanove is not the same as the Arduino DUE. Just noting this as this was posted in the DUE forum. Ok, got it!

Can you download code off an Arduino?

It is compiled machine code what is uploaded into Arduino. You can download it back, but to make any changes you have to decompile it – reverse engineering.

How do I export code from Arduino?

Export Arduino Code to MS Word

  1. From the Arduino IDE, select your code and click Edit -> Copy as HTML.
  2. Paste the text into a textfile and save it with a . html extension.
  3. Open the HTML file in your web browser and copy all text.
  4. Paste into your document in Microsoft Word.