What does it mean when your boiler says A01?
What does it mean when your boiler says A01?
ignition failure
Vokèra Linea fault code 10 (Vokèra Compact code A01) This fault code suggests that there is an ignition failure with the boiler. You might also hear the boiler sparking up but failing to ignite. Potential fix: To fix this issue, your qualified engineer will aim to test the voltage going to the gas valve.
How do I reset my Ariston code?
To reset your Ariston boiler you simply need to locate the reset button and hold it down for up to 10 seconds. All boilers will have a reset button, however, depending on the type of boiler and the make and model, its location might look slightly different.
How do I fix my ferroli A01?
Ferroli A01 Fix Once you remove the debris, your boiler should ignite and work without further issues. However, if the flue is clear of debris, it’s possible that your flue has corroded over time. In this case, a Gas Engineer will need to come and replace the flue and wall clamps.
Do boilers have fuses?
Like most appliances that operate using electricity, a boiler is fitted with a fuse to prevent damage in the event of a power surge. A power surge can damage key components of your boiler, so the fuse functions to break the circuit if it detects a surge so that it does not reach the boiler.
Why is my Ariston boiler not working?
There are many reasons why an Ariston boiler might fail to ignite and most of the possible reasons require a Gas Safe engineer, several of these causes include: faulty ignition leads, broken diaphragms or airlocks, blocked burner, issue with the spark generator, no or little gas supply, low gas pressure and debris in …
How do I reset my Ariston heater?
To reset:
- IMPORTANT: Disconnect heater from electrical power.
- Remove front cover plate (C fig.
- Firmly press reset button (B fig.
- Replace cover plate, reconnect power.
- IMPORTANT: Check the operation of the thermostat, turn temperature dial from.
- If the system works, place dial setting to desired setting.
How do you reset a Ferroli boiler?
Resetting a Ferroli boiler isn’t much of a hassle. All you have to do is locate the reset button normally located at the front of the boiler and hold it down for about 10 seconds. If the reset is successful, the flame will ignite, and the error code will disappear.
Why does my Ferroli boiler keep losing pressure?
Ferroli Boiler Pressure Loss Leaks are the most common cause of any boiler losing system water pressure. Most of the time the leak will occur on radiator valves, or valves on towel rails. However, the leak can sometimes come from the auto air vent in the boiler, or expansion vessel.
Where is boiler fuse located?
If you don’t know where your fuse board is, you can look near the entrance of your property. They’re usually installed quite high up, like this one in the picture. If it’s not there, it’s usually in the cupboard under the stairs. Open the flap and look for a fuse pointing down in the off position.
Why does my Ariston boiler keep cutting out?