What is a flame arrestor on a water heater?
What is a flame arrestor on a water heater?
Modern gas water heaters have a flame arrestor to help prevent the ignition of flammable vapors that may be in the air. CAUTION! Never use or store flammable substances near the water heater. Flammable vapors may be ignited by the pilot light resulting in property damage, serious injury or death.
What does flame arrestor do?
A flame arrestor, also called a flame trap, is a device that stops fluid combustion by extinguishing the flame.
How do you clean a flame trap on a water heater?
To clean the bottom of the flame arrestor, turn the flame arrestor cleaning attachment over and insert it through the air intake opening at the base of the heater, and use a gentle sweeping motion to clean the entire base, see Figure 3. 5. Re-insert the air intake screen when finished.
Do I need a flame arrestor?
Flame arresters are typically used wherever there is the potential for an explosion arising from flammable gas or vapour being mixed with air. Accidental ignition of a flammable mixture will result in a flame that will travel through the unburnt mixture until the fuel is consumed by the reaction.
Where do you put a flame arrestor?
Flame arrester location in the process End-of-line flame arresters (Figure 5a) are located directly on a vessel or tank vent nozzle, or on the end of a vent line from the vent nozzle.
How often should a flame arrestor be cleaned?
Once you’ve broken it loose once it’s really quick and easy to clean. The maintenance schedule says to clean it every 100 hours. From the Indmar manual: Your engine is equipped with a U.S. Coast Guard approved flame arrestor.
Can a dirty flame arrestor symptoms?
A spark plug fouled by fuel, carbon, dirt or oil on the electrodes may not produce a spark strong enough to ignite the air/fuel mixture and start your engine. A dirty flame arrestor/air box can cause your boat engine to stall.
Where should I install a water hammer arrestor?
– Turn off the water faucet more slowly; this allows the water to slow down before stopping. – Tighten any loose fittings on your pipes; this could eliminate your problem. – Check your water pressure; get a pressure gauge and check the water pressure. The water may be entering your house at too high of a pressure.
How to install a water hammer arrestor?
Threaded Fittings. For threaded water hammer arrestors,you can thread the device onto each valve or inlet.
Where to fit water hammer arrestor?
What Is a Water Hammer Arrestor?
Where do you put a water hammer arrestor?
Blacoh™ Fluid Control,Website: http://www.blacoh.com,Tel: 951-239-3930,BLACOH Fluid Control,Inc.