Which connector where you should insert the IDE cable?
Which connector where you should insert the IDE cable?
Connection A plugs into the motherboard and then the slave and master connections are used for IDE devices. If you are only installing one drive or the new drive is to be the master then use the master connector. If the drive is to be the slave then use the slave connector.
What are IDE ports?
IDE, an acronym for Integrated Drive Electronics, is a standard type of connection for storage devices in a computer. Generally, IDE refers to the types of cables and ports used to connect some hard drives and optical drives to each other and to the motherboard.
What piece of hardware do IDE cables connect to?
Integrated Drive Electronics (IDE) is a standard interface for connecting a motherboard to storage devices such as hard drives and CD-ROM/DVD drives. The original IDE had a 16-bit interface that connected two devices to a single-ribbon cable.
How do I connect my IDE drive?
Connect the data cables to mainboard/card IDE/SATA expansion slots. Connect power splitters/adapters if needed; For IDE drives: make sure that the drive jumper (Pic. 1) is set to the “cable select” (CS) mode….
- Back panel of an IDE (PATA) drive.
- IDE (PATA) data cable.
- Back panel of a SATA drive.
- SATA data cable connector.
How do I identify my IDE?
Technically, there are Parallel ATA (PATA) and Serial ATA (SATA), which are both variants of the IDE hard drive interface. However, the term IDE is typically used for a Parallel ATA drives. You can tell IDE from SATA by looking at the hard drive connectors as illustrated below.
How do I know if I have SATA or IDE?
If you have removed the hard drive from your computer and the label is missing or does not display the type of drive, examine the connectors on the back of the drive. IDE connectors have metal pins visible, while SATA connectors extend out like the edges of computer add-on cards.
What does an IDE cable look like?
An IDE cable has a red stripe along one edge, like you see below. It’s that side of the cable that usually refers to the first pin. If you’re having trouble comparing an IDE cable to a SATA cable, refer to the image below to see just how large IDE cables are.